Resetter Printer Canon G2010

Click at the top right to print out a diagnostic sheet confirming that the internal log registers zero prints on the waste tank. Step 4: Finalizing and Exiting Service Mode

The 5B00 error is a built-in safety feature. Every time you clean the print heads or perform a deep cleaning, excess ink is pumped into an internal sponge called the waste ink pad. When the internal counter reaches its limit, the printer stops working and flashes its indicator lights (typically 7 times alternately) to prevent ink from leaking out of the machine.

Keep holding both buttons. While still holding the Power button, release the Stop button. resetter printer canon g2010

While holding the Power button, tap the button exactly 5 or 6 times (depending on your printer's specific firmware revision).

the printer, but leave the power cable plugged into the wall. Click at the top right to print out

Do not try to run this software over Wi-Fi. It will not work and might freeze your printer.

Release the button. The green light should flash and then remain solidly lit. This means you are officially in Service Mode. Phase 2: Reset the Counter When the internal counter reaches its limit, the

While holding the Stop button, press and hold down the button.

A pop-up window will appear saying "A function was finished." Click . Close the Service Tool software.