Sigmastar Sdk Install 2021 -

make all 2>&1 | tee build.log

For a standard Android SDK setup using a private Git server, the steps are generally as follows:

Scroll to the bottom of the file and append the following lines (adjust the directory path to exactly match your extracted compiler version):

pip install enum34==1.1.10 numpy==1.16.6 protobuf>=3.8.0 six>=1.12.0 opencv-python==4.2.0.34 tensorflow==1.14.0 Cython>=0.29.13 pycocotools>=2.0.0 matplotlib>=3.0.3 scipy>=1.3.1 pillow==6.1.0 joblib

Validate that the cross-compiler runs properly and outputs the correct target architecture: arm-linux-gnueabihf-gcc -v Use code with caution. sigmastar sdk install

Getting Started: SigmaStar SDK Installation and Environment Setup

Navigate to the SDK root and build the default project:

sudo apt-get update sudo apt-get install -y build-essential libncurses5-dev libc6-i386 lib32stdc++6 lib32z1 \ libssl-dev gawk make bc bison flex gettext scons python-mako Use code with caution. Copied to clipboard

Navigate to the root directory of your SDK. The first build command you run typically sets up the environment and selects the configuration for your specific board. This configuration file defines the chipset (e.g., infinity6b0 ), flash type ( nor or nand ), root filesystem type ( squashfs ), sensor, and memory configuration. You will often use a script like setup_config.sh : make all 2>&1 | tee build

You can compile the system in parts or all at once.

cd $SIGMASTAR_SDK_PATH make clean # or ./build/clean_all.sh

cat $SIGMASTAR_SDK_PATH/build/config | grep -E "BOARD_NAME|CHIP|UBOOT_CONFIG"

The toolchain is the most critical component. It allows your x86 computer to compile code for the ARM-based SigmaStar chip. The first build command you run typically sets

Add the following to your ~/.bashrc :

for your hardware board using the SDK initialization script:

The SDK relies on a specific environment variable: SIGMASTAR_SDK_PATH . Create a setup script: