Installation Manual ((new)) Full - Thyssenkrupp Levant Stair Lift

Ensure you have the following tools on hand before beginning: (specifically 4mm, 5mm, and 6mm) Socket wrench set (10mm, 13mm, and 17mm sockets)

[ Top Rail Terminal Block ] || || <---- Aluminum Rail Track || +-----------------+ | Drive Carriage | <--- Slide down carefully from the top +-----------------+ || || [ Bottom Rail Terminal Block ] Step 1: Mounting the Carriage onto the Rail Remove the top mechanical stop block from the rail.

The motorized drive unit containing the motor, circuit board, and batteries.

Plug the transformer into a wall socket and connect the wires to the charging contacts. thyssenkrupp levant stair lift installation manual full

Attach the folding footrest assembly to the bottom base of the carriage. Connect the safety-edge wire harness from the footrest to the corresponding plug on the carriage chassis.

Thread the provided splice bolts through the rail and tighten them securely using an Allen key. Ensure there are no gaps or ridges at the joint; the carriage rollers require a seamless transition. Step 2: Positioning the Rail and Attaching Support Brackets

However, I can help you in several practical ways: Ensure you have the following tools on hand

Test the wireless remote units to ensure they can call the chair from either end of the track. Manual Resources

The specific Installation Manual is often sold by specialist retailers like Access2Parts . Levant stairlift User Manual

Plug the multi-pin wiring harness originating from the seat armrest controls into the main circuit board inside the carriage housing. 6. Electrical Connections and Charging System Connect the safety-edge wire harness from the footrest

Spirit level (at least 2 feet long), tape measure, and a chalk line.

Once everything is assembled, turn on the main power switch located on the chassis. Diagnostic Display Codes