This blueprint breaks down essential CLI configurations, navigation commands, system maintenance procedures, and debugging sequences required to optimize your microwave networks. 1. Navigating and Accessing the MINI-LINK CLI
: Activates a loopback on a specific controller for path testing (use no loopback to disable). reload : Triggers a "warm restart" of the node. write : Saves the current configuration to permanent memory. DCN and Service Configuration
: Sends an operator confirmation to save changes for class 1 objects.
show ip interface : Displays all IP addresses assigned to the management interfaces and loopbacks. ericsson mini link cli commands
When a link drops or experiences high bit-error rates (BER), use these commands to isolate the fault. ping [ip_address] Use code with caution.
What specific MINI-LINK model or configuration task (e.g., Radio Link, Ethernet, VLAN) are you working on? Mini-Link CLI | PDF - Scribd
Run a configuration export command before and immediately after any maintenance window. If you need help with a specific task, please let me know: reload : Triggers a "warm restart" of the node
ping 192.168.1.1
: Displays board information including Serial number, Type, and Software version. show board [slot] config : Verifies if a board is in service and enabled. show board [slot] status : Checks if a board is in "repair mode".
Use SSH/Telnet to connect to the NPU (Network Processing Unit) management IP. show ip interface : Displays all IP addresses
: Displays the system event log for historical troubleshooting.
copy running-config startup-config : Saves the current active configuration to the non-volatile storage flash memory.