roughly corresponds to ISO 2081 Fe//Zn 8/A/T0 or similar classifications, depending on whether the chromate is trivalent (Cr3+) or hexavalent (Cr6+).
When migrating to the modern ISO standards, it is vital to explicitly state "Cr3+ compliant" or "RoHS compliant" on purchasing documents to ensure that older, restricted hexavalent chemistries are not used by the electroplating vendor.
Achieving a compliant Fe/Zn 8/B finish requires a controlled, multi-stage electrochemical process:
Corrosion resistance for plated components is standardly verified using a Neutral Salt Spray Test (NST) according to ISO 9227 or DIN 50021. A typical component plated to DIN 50961 Fe/Zn 8b will meet the following minimum thresholds: Corrosion Type Typical Resistance Hours (Salt Spray Test) (Corrosion of the zinc layer) 8 to 24 hours Red Rust (Corrosion of the steel substrate) 48 to 72 hours din 50961 fe zn 8b
The corrosion resistance of a DIN 50961 FE Zn 8B coating is a key performance metric. It is typically validated through the conducted according to DIN EN ISO 9227. Resistance is evaluated based on the time until the first appearance of "red rust" (corrosion of the steel base) or "white rust" (corrosion of the zinc).
This passivation is typically a silver-blue or clear finish. It enhances corrosion resistance compared to unpassivated zinc and acts as a base for subsequent coatings.
If you are looking for the current equivalent to , you should look at ISO 2081. roughly corresponds to ISO 2081 Fe//Zn 8/A/T0 or
Understanding DIN 50961 Fe/Zn 8/B: The Standard for Zinc Electroplating
During the acid pickling and electroplating phases, atomic hydrogen can penetrate high-strength steels (typically those with a tensile strength over 1000 MPa or hardness above 310 HV). This can cause the steel to become brittle and fail catastrophically under load. To prevent this, parts must undergo a (typically at 190°C–220°C for several hours) immediately after plating and before the passivation layer is applied. Significant Surfaces
Understanding DIN 50961 Fe/Zn 8/B: A Guide to Zinc Electroplating Standards A typical component plated to DIN 50961 Fe/Zn
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Small hardware where a "bright," clean metallic look is required.