Bradex Bx60 Battery Charger Manual Full Fixed -
Do not use with non-rechargeable batteries or lithium-ion batteries.
No earthing/grounding wire is required for safe operation. 2. Operating Instructions
| Mode | Battery Type | Voltage | Use | |------|-------------|---------|-----| | STD | Standard lead-acid (WET) | 14.4V | Car, truck batteries | | AGM | Absorbent glass mat | 14.7V | High‑performance/stop‑start | | GEL | Gel battery | 14.2V | Deep‑cycle, solar | | RECON | Desulfation mode | 15.8V (pulsed) | Reviving sulfated batteries |
Use a wire brush to remove any corrosion from the battery posts to ensure a strong connection. 2. Connection Sequence bradex bx60 battery charger manual full
The front panel of your Bradex BX60 utilizes visual indicators to communicate status:
Wind the cables cleanly around the integrated hooks. Store the mobile unit upright in a dry, dust-free environment out of direct sunlight. Troubleshooting Guide Probable Cause Corrective Action Charger will not turn on; ammeter stays at zero. No AC mains power or internal thermal cutout tripped.
Once charging is complete, follow the exact reverse order to disconnect: Unplug the AC power cord from the wall. Remove the clamp. Remove the Red (Positive/+) clamp. Using the Engine Start Feature Do not use with non-rechargeable batteries or lithium-ion
Disclaimer: This guide is a general overview of similar models (Bradex BX60). Always refer to the specific paper manual included with your purchased unit, as specifications may vary by manufacturer.
Optimized for 12V lead-acid batteries with a 4A RMS (approx. 2.8A DC) charge rate.
Prevents damage if the clips accidentally touch. Operating Instructions | Mode | Battery Type |
This comprehensive manual covers technical specifications, safety protocols, step-by-step operating instructions, and troubleshooting procedures for the Bradex BX60. 1. Technical Specifications
Locate the toggle switches on the front panel of the Bradex BX60.
Place the charger as far away from the battery as cables permit. Never place it directly above the battery, as rising corrosive gases can damage the unit.
Before starting, ensure the charger is from the mains. Preparation :
Bradex BX60 is a 4A 12V manual battery charger suitable for lead-acid batteries. It features a built-in ammeter to track charging progress and includes safety protections against short circuits and reverse polarity. Tayna Batteries Quick Setup & Operation Preparation : Ensure the charger is from the AC wall outlet before starting. Connection Attach the Red (+) clamp to the positive terminal of the battery. Attach the Black (-) clamp to the negative terminal of the battery.
