- ←
-
This consolidates manufacturer data, user experience, and technical specifications to help you install, configure, and troubleshoot your KT-70 display safely and effectively.
The Kt 70 is generally low-maintenance, but follow these tips:
was a pioneer in the "Silver Crown" line, offering Mode S compatibility in a compact, panel-mounted design. To install it correctly, you need the official documentation—specifically Manual #006-00673-0002 (or the earlier 006-00673-0001). 1. Manual Overview & Key Specifications The KT 70 installation manual typically spans about
If you need help with a specific part of your installation, please tell me:
Disclaimer: This write-up refers to the Polycase KT-70 plastic electronics enclosure . If you are looking for the Bendix/King KT-70 Mode S Transponder, the installation manual is a separate, specialized aviation document (often referenced as 006-00673-0002). Kt 70 Installation Manual
200 Watts minimum pulse power at the antenna. TSO Compliance: TSO C112 (Class 2A). Weight: 3.1 lbs (1.41 kg) with mounting rack. Required Tools and Equipment
What are you installing this unit into?
If connecting an older blind encoder or encoding altimeter, run the lines (A1 through D4) directly to the corresponding pins on the KT 70 rear connector.
The KT 70 relies on an external blind encoder or air data computer to transmit Mode C/S altitude data. It accepts standard parallel Gillham code (Gray code). Gray Code Connections 200 Watts minimum pulse power at the antenna
While you can manually toggle between and ALT modes, the installation manual details an optional remote air/ground switch that can be installed on the landing gear. This automatically transitions the unit to the correct mode upon takeoff, significantly reducing pilot workload. Manual Resources
– Solid, not stellar. Gets the job done, but leaves room for improvement in visual design and beginner support.
The KT 70 requires a standard L-band blade or transponder whip antenna (monopole). RF signal loss can degrade transponder performance, causing dropped radar targets. Coaxial Cable Specifications 50 Ohms.
Select a position in the avionics stack away from high-heat sources and heavy magnetic interference (such as compasses). Steps for configuration
Steps for configuration, calibration (such as display brightness adjustments), and functional testing. Key Technical Specs Operating Modes:
The unit operates on 14/28 VDC. Use a 5-amp circuit breaker. Key Connections:
: This is a tool for workshops. A micro-coordinate table is used with a drill press or milling machine to position workpieces with extremely high precision.
Keep the antenna at least 36 inches away from any DME antennas, ADF loops, or other transponder antennas to prevent receiver front-end desensitization.