Pacific Fitness Del Mar Home Gym Assembly Manual (2026)

Cable routing is the most intricate part of assembling the Pacific Fitness Del Mar. The gym utilizes distinct cables: the , the Press Arm/Floating Pulley Cable , and the Low Row Cable .

Insert the pivot shaft and tighten the retaining bolts. Verify that the press arm swings smoothly without lateral wobbling. Step 4: Seat, Backrest, and Leg Developer

Ensure all bolts and nuts are securely tightened. However, as noted in general, many fitness gear assemblies recommend leaving some poles slightly loose initially to align pieces before final tightening. 2. Pacific Fitness Del Mar Assembly Steps pacific fitness del mar home gym assembly manual

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

: Ensure the cables rest deeply inside the grooves of each pulley wheel before tightening the pulley bolts. Cable routing is the most intricate part of

Open-end or combination wrenches (9/16" and 1/2" are standard for these bolts). Allen Wrench Set: For securing set screws and pivot points.

: Only hand-tighten bolts during the initial frame setup. Do not fully tighten until the entire structure is aligned to prevent warping. Lubrication Verify that the press arm swings smoothly without

Attach the and Backrest Support to the front upright. Install the pop-pin adjustment knobs into the threaded housings. Step 5: Cable Routing and Pulley Integration

Always install the pulley retention bolts tight enough to hold the pulley, but ensure the wheel spins completely free. The Cable Paths

Pacific Fitness Del Mar Home Gym Assembly Manual & User Guide

Once all cables are routed, adjust the tension using the threaded bolt at the weight stack. There should be minimal slack in the cables, but they should allow the weight stack to rest fully on the base without lifting off the ground. Step 6: Seats, Pads, and Upholstery