Version 3.4 or higher resolves the Windows 10/11 connectivity loop. Option B: The FTDI Chipset (Premium/Older Models)
Set the Baud Rate to (standard for Jinka) or 38400 (depending on your specific motherboard version). Set Flow Control to Hardware or RTS/CTS . Configuration for Artcut Launch Artcut and open a new document. Click the Cut/Plot icon.
Your fixed driver creates the bridge, but your design software must know where to cross it. Here is how to map the connection in the three most popular programs. ArtCut Configuration Open ArtCut and go to the screen.
Once the fixed driver is successfully installed, you must align your software settings with the designated COM port assigned by Windows. i download fixed driver cutting plotter jinka 1351
While CorelDraw with SignTools is the most common setup, you are not limited to it. Here are some excellent alternatives:
The issue? A silent Windows security update had revoked the old, unsigned driver I was using. The Jinka 1351 isn't a big-budget HP or Graphtec; it’s a reliable Chinese import that uses a generic driver architecture. When that driver breaks, finding a replacement is a treasure hunt.
Right-click the broken Jinka device and select . Check the box "Delete the driver software for this device." 3. Install the New Driver: Run the CH341SER.EXE installation file and click Install . 4. Connect the Plotter: Turn off the Jinka 1351. Version 3
: Before running any installers, disconnect the USB cable from the PC. This prevents Windows from automatically assigning an incorrect generic driver before your specialized one can be applied.
How to Download and Install the Fixed Driver for the Jinka 1351 Cutting Plotter
By following this guide, you should have successfully installed the fixed driver for your Jinka 1351. Let me know: What are you using (Windows 10/11)? Configuration for Artcut Launch Artcut and open a
Use a high-quality USB 2.0 cable, ideally one with a ferrite bead (the cylinder bump) to reduce interference.
If you are using a Serial (COM) port for connection, you must manually configure the settings. Open your cutting software, find the "Plotter Settings" or "Device Setup" section, and enter the following parameters exactly:
Don’t waste time doing what I did first: