Uncrate the cabinets and cross-reference the serial numbers with the packing list.
Connect communication cables for access control systems (card readers, biometric scanners).
Before installation begins, the following conditions must be met to ensure compliance with the manufacturer's warranty and operational safety. gunnebo speedstile fl installation manual
Connect the incoming AC mains ground wire directly to the chassis ground terminal.
The SpeedStile FL system consists of Master (Left), Slave (Right), and optional Intermediate (Center) cabinets for multi-lane configurations. Uncrate the cabinets and cross-reference the serial numbers
Minimum C20/25 compressive strength is highly recommended.
, I can check if there are specific or sensor calibration steps unique to your unit. Connect the incoming AC mains ground wire directly
Follow these procedures to ensure the units are aligned and secured correctly: Gunnebo SpeedStile FL
Install RFID, barcode, or biometric readers under the glass top lid or within the dedicated reader brackets. Step-by-Step Signal Termination:
: Attach flap leaves to the rotor drive column and install lids and covers once wiring is complete. SpeedStile FLs BA|EV - Protogetic
Verify reader relay is connected to "Dry Contact" input, not voltage output. "Fire Alarm" error on control board Open circuit on emergency loop