On the login page, look for the link. If you previously configured Security Questions , you can answer them here to regain access instantly.
Inspect the motherboard for a small tactile button labeled or two solder pads labeled J1 / JP1 / RESET . If using a button: Press and hold it down.
A: No. The password is stored on a separate flash memory chip on the main circuit board, not on the hard disk drive. Even a factory reset should have no effect on the physical hard drive or its ability to read and write data. hi sharp dvr reset password new
: Use a Phillips screwdriver to remove the screws securing the metal casing.
To resolve a issue, you can use factory defaults if it is a fresh setup, deploy the dynamic code method for a forgotten credential, or perform a hardware reset. Method 1: Use the Factory Default Credentials On the login page, look for the link
Contact your local Hi Sharp distributor or technical support agent.
A common myth is that removing the CMOS battery on the DVR's motherboard will reset the password. Doing so might only reset the date and time. The password and main settings are stored in non-volatile flash memory, not volatile CMOS RAM. Removing the battery simply wastes your time and effort. If using a button: Press and hold it down
Most Hi Sharp DVR devices have a reset button located on the back or bottom of the device. Here's how to use it:
| Model Series | Default Username | Default Password | | :--- | :--- | :--- | | | admin | 123456 | | 960H / AHD Series | admin | (blank / empty) | | Older MJPEG | admin | admin |
If you give your DVR model number (printed on the unit) I’ll provide model-specific reset steps.
If software methods fail, you can perform a factory reset via the motherboard: