Crdroid Bootimg | Install Repack

fastboot set_active other fastboot flash boot crdroid_boot.img

Modifying your device’s firmware carries inherent risks. The author and crDroid project are not responsible for bricked devices, lost data, or voided warranties. Proceed at your own risk.

Why this matters: Many users skip the boot image step when dirty flashing. The crDroid updater script includes package_extract_file("boot.img", "/dev/block/bootdevice/by-name/boot") , so as long as you flash the full ROM zip, you are safe. However, if you manually extract and flash only boot.img without the system components, you will face a version mismatch.

In crDroid Recovery, select > Format Data/Factory Reset . Select Apply Update > Apply from ADB . On your computer, type: adb sideload crdroid.zip Use code with caution. Once completed, reboot your system. Troubleshooting: Common bootimg Installation Issues Potential Cause Device stays on Fastboot Incorrect boot.img

Once the installation is complete, select Reboot system now from the recovery menu. crdroid bootimg install

Select in the recovery menu, then choose Reboot to Recovery to refresh the partitions. Select Apply Update > Apply from ADB again. Run adb sideload gapps_file.zip on your computer. Step 6: Reboot and Initial Setup

Last updated: October 2025 – Compatible with crDroid 10.x (Android 14) and later.

Note: If your device uses a separate vendor boot image (common in Android 12+), you may also need to flash it: fastboot flash vendor_boot vendor_boot.img Use code with caution.

Replace crdroid_boot.img with the actual filename. fastboot set_active other fastboot flash boot crdroid_boot

: Ensure your path points exactly to the platform-tools folder. On macOS/Linux, prepend commands with ./ (e.g., ./fastboot flash boot boot.img ). Device Stuck in a Boot Loop (Stuck on the Logo Screen)

Return to the main menu and select > Apply from ADB .

You should now see the purple/blue crDroid Recovery interface on your screen. Step 6: Next Steps to Finish ROM Installation

Your installation is now complete, and you can safely boot into your new operating system. Navigate back to the main menu of the crDroid recovery. Select . Disconnect the USB cable from your phone. Why this matters: Many users skip the boot

The best way to illustrate these paths is with concrete examples, using the official instructions from crdroid.net.

You attempted to flash the boot image without disabling zip signature verification. Fix: You can safely ignore this if you trust the source. TWRP → Settings → Uncheck "Enable signature verification" for images.

Your terminal is not running inside the folder where fastboot.exe is located.