Jis G 3193 Pdf -

For plates with a width up to 2000 mm, the permissible variation for a nominal thickness of 6 mm is typically ±0.35 mm (for specified minimum tensile strength < 400 N/mm²). Tighter tolerances apply for higher strength or wider plates.

standard, perfect for sharing as a blog post or professional update.

The standard ensures that the actual thickness, width, length, and flatness of the steel produced conform within acceptable limits to the ordered dimensions.

Tolerances in JIS G 3193 are categorized by thickness, width, length, and flatness. These values change depending on the nominal dimensions of the steel plate. 1. Thickness Tolerances

The official PDF contains comprehensive tables comparing thickness, width, length, and flatness tolerances, which are required for procurement. jis g 3193 pdf

I cannot directly create or generate a PDF file, nor can I retrieve the full text of (Japanese Industrial Standard for dimensions, tolerances, and mass of steel plates, sheets, strips, and flats) due to copyright restrictions.

While this article outlines the basics, accessing the full from authorized sources like the Japanese Standards Association (JSA) is vital for several reasons:

Requirements for appearance, standard dimensions, and tolerances for hot-rolled steel products, including cut lengths from steel strips. Exclusions: This standard is specifically not applicable to flat bars International Correspondence: It is a modified version of ISO 7452:2013 , adjusted to reflect Japanese transactional practices. Building CodeHub Standard Specifications & Tolerances

Usually allow strict tolerances between ±0.20 mm and ±0.35 mm depending on width. For plates with a width up to 2000

Disclaimer: This article provides a summary for informational purposes based on publicly available information. Always refer to the latest official JSA document for technical compliance.

Generally refers to flat-rolled steel with a thickness greater than or equal to 3.0 mm.

If you need help from the standard, calculating the permissible flatness deviation for your plate size, or finding the material standards that pair with this document, let me know how you would like to proceed.

In construction, "close enough" is rarely acceptable. The standard defines the allowable deviations in: The standard ensures that the actual thickness, width,

Carbon steel plates for general structures (e.g., SS400).

Some universities with Japanese engineering programs have site licenses for JIS standards. Check your institution's library portal. However, distributing single PDFs outside the network is prohibited.

: Hot-rolled steel continuously rolled and wound into coils, which can later be cut into custom sheet lengths. Note: This standard does not apply to flat steel bars. Standard Dimensions (Thickness & Width)