| Specification | Value | | :--- | :--- | | | Automatic Battery Charger | | Compatible Battery Types | All 12 V batteries (standard motor vehicle starter batteries, boat batteries, etc.) with a capacity not less than 5 Ah | | Compatible Battery Voltage | 12 V | | Maximum Charging Current | 8 A (arithmetic mean) | | Cutoff Voltage (Standard Battery) | 14.4 V | | Cutoff Voltage (Maintenance-Free) | 13.8 V | | Key Features | 12-volt output, LED charging indicator, reverse polarity protection, automatic charge termination, deep discharge protection | | Battery Test Capability | As battery test indicator for capacities between 24 to 66 Ah | | Buffer Operation Max Load | The maximum current of the load must not exceed 5.6 A - 0.013 x battery capacity (e.g., for a 84 Ah battery, approximately 4.5 A = approximately 55 W) |
Key features and specifications include:
: There are no user-serviceable parts inside. If the power cord is damaged, it must be replaced by an authorized professional. electronic power systems pty. ltd. bosch kl 1208 battery charger manual exclusive
Before using the Bosch KL 1208, carefully read the following instructions. Incorrect handling can damage the battery, the charger, or even cause personal injury.
Only after the clamps are secure should you plug the charger into the mains. Flip the power switch to the (I) position; the red center LED will illuminate. | Specification | Value | | :--- |
A: The electronic regulation circuitry means the battery cannot be overcharged. The switch can remain in the "ON" position for several weeks without supervision. However, for safety and to prolong battery life, it's best to disconnect the charger once the battery is fully charged unless maintaining a float charge is required.
: Designed for 12V lead-acid batteries with capacities ranging from approximately 2.5 Ah to 90 Ah. Safety First Only after the clamps are secure should you
The Bosch KL 1208 uses a simple but effective light system to communicate status: Light Signal Action Required Unit is ON None; charger is powered. Yellow (Flashing) Wait for the cycle to complete. Yellow (Solid) You may terminate the process. Green LED (on some models) State of Charge Will cease to glow once approx. 80% charge is reached. Exclusive Performance Tips
Can reach an 80% charge for a 50 Ah battery in approximately 8 hours. Operating Temperature: Ideal between 0°C and 35°C. Step-by-Step Operating Instructions
Standard lead-acid (Flooded/Wet cells) 2. Safety Precautions and Hazards